Inventor-Using the inventor software, I created a circle and dimensioned the diameter, being careful to keep it under
|
Next in Inventor, I extruded everything but the channels. I made sure to keep those for my second extrusion.
|
For the channels, I added another extrusion going the other way, making sure to keep it at the correct dimensions. The next step before the mill is to set it up in Fusion 360!
|
Mill-Down in the Innovation center, I used the router. After taping it down and setting all axis to line up with my center point I successfully cut out my maze.
|
With the help of Adobe Illustrator, I engraved my name onto my maze. Since there was little amount of space, I had to strategically engrave it on the longest arm, making it small enough to fit.
|